It’s now the time to install the Flight Control Board (CC3D) and to connect it to the different components of the quadcopter… as usual here’s the videotutorial with english subtitles:
I mounted the flight control board using four plastic spacers: very important is to install it with the arrow printed on the PCB that points to the “forward” direction of the quad:
To correctly power the flight control board, you have to remove the red wire (5V) from three of the four ESC connectors. I’ve also temporary connected the motors to the ESCs to be able to swap two of the three wires if needed (to revert the rotation direction of the motor):
At the end, I connected the receiver using the cable provided with the CC3D and following the wiring diagram on the wiki:
Ciao Luca complimenti per il sito! Ma la stessa cc3d può essere usata anche per un quadricottero f450?
Ciao! Assolutamente sì!